Meyer Sound QuickFly Especificações descarregar pdf (Página 42)

MG-MICA MULTIPURPOSE GRID AND ACCESSORIES

PN: 05.147.034.01 A

Page 42 of 44

Meyer Sound Laboratories Inc.

www.meyersound.com

T: +1 510 486.1166

F: +1 510 486.8356

Figure 9.1. MICA can pivot over 30 degrees on front link to aid rigging

CAUTION: If the links are not stowed as described in Step 8, you run the risk of denting or penetrating

the wood on the top loudspeaker in the stack by hitting it with an extended link.

11. Pin the front links in the 0 position (unless the +7 position is required). Position and pin the rear links of the

suspended MICA loudspeaker to the desired angle. “Bump” the motors to lower the rear GuideALinks into the link

pockets of the MICA to be attached, and pin.

12. Repeat the previous steps until the array has been assembled. All loudspeaker-to-loudspeaker links are made with

the Blue-button pins.

NOTE: As more loudspeakers are being added to the suspended array, keeping the grid as close to

parallel as practical to the stage surface will ease the process of adding more loudspeakers to the array.

This prevents the center of gravity from falling in front of the downstage motor, and making it virtually impossible

to control the angle of the grid — complicating the attachment of the rear links. In some cases when the array

length is longer than 10 - 12 loudspeakers, it may be necessary to push the suspended array toward the upstage

direction and lower the array to close the gap between the rear of the ﬂown and stacked loudspeakers.

TIP: As the ﬂown array is being assembled and raised, the front GuideALinks on MICA can rotate over

30 degrees forward while pinned, facilitating the connection of the ﬂown, angled array to the stacks of

loudspeakers positioned on the caster frame. Roll the stack in place so that the front links mate, pin them, and

then lower the array slightly so that the rear links can be pinned. Finally, unpin the caster frame from the lowest

enclosure. Reverse the procedure when striking the array.

1 2 ... 37 38 39 40 41 42 43 44

Sem comentários

Meyer Sound QuickFly Especificações Página 42